Rohde & Schwarz Video Noise Meter Model UPSF2
Specifically designed for the measurement of spurious modulation from the television transmitter (see the block diagram providing a typical setup)

**MODULE ONLY**
Old technology although still in use until 2002 at an Australian National Broadcast facility, but this module could be useful for a UPSF2 restoration project
OR
Cannibalise for parts! (see description below for parts of “note”)
MODULE: IEC Interface
Part number: 341.8238.02
Slot position A12

COSMETIC CONDITION:
Clean with no damage at all

TECHNICAL DETAILS:
Double sided PCB
Open Frame
No SMD
A number of MKT .1u/100V capacitors, Roederstein series EK electro’s, 100pF ceramics and a nice Siemens push on push off switch (internal hard reset)
Active components: 2x 2732 250nS eprom set (347.5124.D8 & 347.5138.D9), Intel P8291 GPIB/IEEE 488 Rx/Tx interface, MC3448 4x Quad OP amp, Intel P8185 (sram 1Kx8 200nS) – these devices are all in sockets. Various 74LS series support logic, all board mounted.

TESTING:
Fully functioning prior to removal, equipment now obsolete (broadcast analog video test equipment)

Stored/supplied in sealed plastic